
In the upper part of the Layer editing function group you will find a list of the layers or layer groups already present. At least one layer belongs to each page/master page, but this is empty at first when the page is created. If you should use more than 24 layers on a page/master page, you can browse through the list with the arrows and scroll bar as usual.
To select a given layer, just click on its name in the list.
With the two list fields PREVIOUS LAYER
and NEXT
LAYER
you can make the selection wander up or down one entry at a
time in the layer list. This way you can reach all layers conveniently
without having to scroll the list itself (we recommend you to record
this as a macro).
To alter the name of a layer, its ID or its protection, hold down the [Alternate] key while you click on its name in the list. That brings up a dialog in which you can alter the parameters of the layer.
To switch a layer visible/invisible, click on the small field in front of the layer name in the list. A layer switched to invisible will be indicated by a horizontal dash, a visible layer normally shows a small colour patch.
To protect a layer, hold down the [Alternate] key while you click on the field in front of the layer name in the list. A protected layer is indicated by a diagonal cross in front of the layer name.
Warning: The markings can not be combined. If the layer is
both protected as well as invisible, the more important status for
invisible
will be displayed.